The easiest way to unlock a padlock

The method of unlocking the ordinary padlock is to use iron wire, find a relatively hard iron wire, straighten it and bend it upward at the end, insert the wrench, and then insert the wrench into the lock hole, remember to insert it into the lock hole next to the lower key tooth. On the one hand, after the correct position, start to increase the strength, and continuously increase the strength of the wrench, until you know that you can pick up the pins, and then turn the wrench forcefully.
 
1. Find a master key, insert the master key into the lock cylinder, tap the other end of the key with a hammer, and try to twist the master key while beating, most of which can be opened.
 
2. Find a useless card, insert the card into the door gap, slide the card to the position of the lock tongue, and squeeze it inside to open the lock. This is a simple and practical method.
 
3. Find a metal wire and a metal wire, fold one end at 90°, and sweep it back and forth near the marble in the keyhole. If you are lucky, fold the other end at 90° and swipe back and forth near the marble in the keyhole. Good luck opening.
 
4. The general padlock has a lock core. In addition to the hole for the key, there are several round holes on the lock core. These round holes correspond to the several round holes on the lock body, and a spring can be placed in it. and 2 copper marbles of different heights.
 
After inserting the key, the two marbles are pushed to different heights due to the difference in the tooth position and height. If the boundary between the two marbles happens to be at the same height as the circumference of the lock core, the lock core can be transferred to the lock body, so , the lock is opened.
 
The materials to be prepared are pliers and clips. The clip is generally a book clip for paper clips. The steel wire on this book clip is thin enough, and the hardness is relatively good, so it is not easy to bend. At the same time, according to the size of the lock, select the appropriate thickness and length of the book clip wire. First, remove the wire on the book clip, twist the wire straight with pliers, and twist one end of the wire into a 135-degree angle. The length of the twist angle is about 5 mm, which can be adjusted appropriately according to the size of the lock. Then twist the other end of the wire into a 90-degree angle, leaving an unlimited length, which is convenient for pulling the wire by hand when unlocking. Secondly, insert the iron wire into the lock core after it is done, pay attention to insert it close to the narrow side until it is inserted to the bottom. After the iron wire is put in, twist the iron wire against the unlocking direction until the spring inside the lock is just toggled, the padlock tongue will shrink into the lock with the spring, and the lock can be opened.
 
Finally, you can use the Lock Picks tools to open the padlock, lockpickmall.com is the best place for you to get them with the lowest price ever!