How to open a drawer lock without key in 5 seconds

How do you open a drawer when the key is lost? If you encounter the same situation as described, then you can just read this short article and find the answer!
 
1. Use a knife to open the drawer quickly
It is an easy and quick method; moreover, it also prevents damage. Now, you have to insert the front and thin side of a knife into the lock and keep inserting them until you feel its edge hits with something.
 
The binding force through this gadget allows the pin to raise and keep all of them above the shear line. Now, move the knife up and down for 10 to 20 seconds. During this procedure, the up and down movement of the knife sets the pins at the same height as the key sets them. You can also do this by one more process, insert them into the bottom side and rotate them slightly in a circular motion. You can also push the top side with thin metal wire and give them a jerk to unzip all the pins simultaneously. These methods couldn’t damage the whole system; you can use them again.
 
2. Drilling
Drilling a lock should only be done in a time crunch, and as a last resort.  The drill will destroy the internal components of the lock and render it unusable. After the act, you will have to replace the lock and potentially other parts of the door.  However, if someone is in danger or requires immediate assistance, this may be your only option.  In that case, find the right sized drill bit, drill the top part of the key path (where the pins are located). Don’t push too hard, and slowly go through each pin (there are 5-6 pins in most of the locks). Eye protection may be a good idea to shield yourself from any flying metal.
 
3. Paperclip
Straighten two paperclips. If you paper clip has a plastic coating, peel away the coating with your fingers so that there is only the metal part of the paperclip. One of the paperclips will go in the lock and the other will aid the other one by pressing on the tension wrench in the desk.
 
Insert the other paperclip, so that it is parallel with the other paperclip. This paperclip will sustain pressure on the lock cylinder. Apply pressure to the paperclip and move the paperclip upward against the pins.
 
Turn the pins in the lock with the paperclip until the lock opens. The parallel paperclip applying pressure against the lock cylinder will begin to move and you should allow the paperclip to move with the internal mechanics. Open the drawer and leave it slightly ajar until you find the key.
 
Finally, you can also prepare some Cheap Lock Pick Set at lockpickmall.com. All the lock picking tools are all in biggest promotions, which can help you save up to 50% off!